- Instacal install with labview install#
- Instacal install with labview drivers#
- Instacal install with labview software#
Select the device on the PC Board List and then select Install✼onfigure. Select the device and click Add.Įach added device is listed on the PC Board List.Ĭonfiguring a Device To configure a device with InstaCal, complete the following steps: 1. Click on the tab that corresponds to the type of device you want to install. Select Install✺dd Board to display a group of tabs. Select the devices to add to InstaCal on the Plug and Play Board Detection dialog box and click OK.Įthernet and Other Devices Complete the following steps to manually add these types of devices to InstaCal after they are connected to the computer or network. USB, Bluetooth, WEB, and PCI Devices These device types are automatically detected by InstaCal, which prompts you to add the device to the InstaCal board list. Running a supported Windows operating system is the only requirement for installing InstaCal.Īdding a Device Once you launch InstaCal, how you add your device to depends on the type of bus interface.
Instacal install with labview software#
Getting Started with InstaCal InstaCal is a software utility for installing, configuring, testing, and calibrating MCC devices.
Instacal install with labview install#
Do not cancel this wizard or the device will not install properly.
Instacal install with labview drivers#
This wizard is required to install additional drivers specific to this device. ‡ Some MCC devices – such as USB-2500 Series or USB-2404 Series – display an additional prompt while installing. PCI-DAS1000 Series, PCI-DAS1200 Series, and PCI-DAS1600 Series devices are not supported on 64-bit operating systems. ISA and PC104 devices are only supported by Windows XP. Note: Refer to to download and install the latest updates to the MCC DAQ software. Guide so that it gets detected by Windows ‡. Install your device by following the instructions in the hardware user's Each selected software package is installed one after the other using separate installers, so make sure each installer finishes completely. Click Install and follow the instructions to install each software package. Insert the installation CD and wait for the setup program to start.Īll software packages are selected for installation if the requirements for the package are met. Install the MCC DAQ Software and Hardware To install the MCC DAQ software, complete the following steps: 1. MCC USB, Bluetooth®, Ethernet™, WLS, WEB, and most PCI devices are supported on 64-bit Windows operating systems †. ISA, PC-CARD/PCMCIA and E-PDISO16 devices are only supported on Windows XP. You can install MCC DAQ Software from the CD on a computer running Windows 10/8/7/Vista/XP * (32- or 64-bit). Getting Started with MCC DAQ Software Please read this booklet completely before you install your Measurement Computing Corporation (MCC) software or device. 10 Trademark and Copyright Information.11 Notice. 8 MCC Hardware User's Guides and Data Sheets. 7 Getting Started with ULx for NI LabVIEW. 6 Getting Started with the UL for Android. 6 Getting Started with the Universal Library (UL). 4 Install the MCC DAQ Software and Hardware.
Table of Contents Getting Started with MCC DAQ Software. Windows and Android™ programming libraries and examples ™